The P3 Vent Integrated Digital Interface or VIDI allows you to connect to your car in an entirely new way. The VIDI is more than just a gauge, capable of displaying dozens of engine parameters the VIDI is the first and last gauge you will ever need. In addition to displaying engine parameters, the VIDI is capable of recording 0-60mph times. P3 understands that a gauge can be difficult to read under racing conditions especially when trying to keep control of your vehicle. For that reason the VIDI features peak recall to show the peak value of any parameter as well as a 15 second playback.

Have a check engine light? The VIDI is capable of reading fault codes as well as clearing a check engine light. All units of measure can easily be adjusted from U.S. (PSI, Fahrenheit, MPH) to metric (Bar, Celsius, KPH). The VIDI can also display values from external 0-5 volt sensors including air ride suspension pressure and many others.

This VIDI kit features a plug and play installation that can be completed in approximately 30 minutes. Simply follow the instructions and easily install the VIDI display in your car's existing vent housing. Once the display is installed simply plug in the included cable to your car's OBD-2 port located near the driver's feet and you're done.

The optional analog boost sensor allows your VIDI to more precisely measure vacuum and boost up to 28psi. This is needed for modified vehicles which are exceeding the measureable range of the factory boost pressure sensor.

For the track driver or avid enthusiast, the Track Pack is a must. This optional upgrade allows your VIDI to accurately display air fuel ratio (Lambda) and features enhanced timers to measure 0-100mph, 60-130mph, 100-0mph, and 60-0mph.

The VIDI displays the following parameters :
Boost/Vacuum
Coolant temperature
Intake air temperature
Exhaust gas temperature
Throttle position
Speed
RPM with selectable shift light
Battery voltage
0-60mph acceleration